HiperTFS - Remove Stanby How to
Posted by: LinuxGuru
on
Hi !
How to completely. remove standby circuitfrom from HiperTFS typical schematic, for example from RDR249?
Which components should be taken out?
Is there any design reference for HiperTFS w/o standby?
Thanks in advance.
Hi,
We do not have any reference design readily available, but I can suugest you from the RDK-249 schematic.
Please find the attached picture and follow the below steps
See the red Boxesnombered in the schematic.
1 - Remove all the components in this rectangle
2 - Remove all the components in this rectangle
3 & 4 - Remove all the components in this rectangle if you don't need remote on-off circuit.
5 - Implement the short for the three traces shown if you are removing componets from 3&4
6 - Remove all the components in this rectangle
Keep in mind that you need to feed external bias voltage around 15V at C20 to power up the TFS
Regards,
PI-NANO