Need expert advice
Hi, we are starting the development of a 400W, 230v input, 24V output supply.
Please guide me about the most efficient and racional aproach, because I can't decide about the IC to use.
These are the caracteristics needed:
input: 190 to 260 VAC
freq: 50Hz
PFC: yes (0.98/0.99)
power: 400W
output: 2 versions, one 14Vcc and another 24Vcc
IP67, epoxi encapsulated
thermal target average 55/60°C (on 25°C ambient)
Also, derived from this supply would be a smaller version (250W) so a basic compatibility on components is a must (for production line)
If the peripheral components could be trough hole, would be great, we prefer that to SMD
We decided to buy the mangnetics samples from you (rapid transformer service) and production from one of your partners.
Thanks in advance.
Leonardo Cei R&D head Engineer SM Electronica, Buenos Aires, Argentina.
Hi,
I would recommend you to use the following devices
for 400W you can use the following devices
PFC Stage : PFS725EG
DC/DC Stage: LCS708HG
for 250W you can replace the devices with following
PFC Stage : PFS724EG
DC/DC Stage: LCS703HG
Trnasformer samples you can order through PI website.
Regards,
PI-NANO