LinkSwitch-XT2 (LNK3696) with opto feedback
Posted by: Michaelhaar
on
What's the proper circuit if I want to use a LinkSwitch-XT2 with an opto coupler in the feedback loop?
I've the problem, that the LNK3696 blows up at turn on.
Files
Attachment | Size |
---|---|
Measured Drain-Source Voltage | 170.56 KB |
Schematic | 25.35 KB |
Is the BP/M loop in layout short? IC will blow up if the loop noise is high, which could be caused by long supply current loop to IC BP/M pin. Could you check if this is a possible cause for the blow-up? Make BP/M loop in layout as short as possible.