Solution Finder Get Tech Support

Technical support for Low power AC to DC converter

Posted by: Mhetre Ganesh Ramdas on

<p>I am going to design DC break driver which is operate on 220VDC,<br />My requirement is Input 230Vac with 50Hz and output is 220VDC with 0.5A for 5Sec (Drive voltage),&nbsp; after 5sec same output will be drop down to 110VDC (Holding voltage).</p>

Comments

Submitted by PI-ODO on 05/05/2017

Dear Mhetre Ganesh Ramdas,

 

It is not clear what your question is, but if you are asking for recommendations for a power supply design meeting the specs you have noted, the PI Expert tool typically does not support designs with an output voltage beyond 100V.

 

-PI-ODO