Problem Designing transformer using PI Expert
Posted by: rohithadapad
on
Hello,
We are designing the transformer for the flyback power supply with multiple outputs. 5V/0.5A, -5V/0.1A, 12V/0.1A, -12V/0.1A, 24V/0.1A. We are using PI Expert for the design.
But PI Expert software is not accepting 2 negative voltages.
How can I design transformer for this using PI Expert?
Dear Rohithadapad,
Thank you for choosing Power Integrations.
I would like to verify if you are using INNOSwitch-3 as your solution.
Also, do you have preference between AC-stack or Separate individual winding for your outputs?