"RIL, KOhm" field is empty.
Posted by: Serg_Avdjushin
on
TOP259EN Current limit.
In my design the "RIL, KOhm" field is empty.
Shall I use RIL=0 Ohm? Is it Correct?
TOP259EN Current limit.
In my design the "RIL, KOhm" field is empty.
Shall I use RIL=0 Ohm? Is it Correct?
© 2024 Power Integrations. All Rights Reserved
Hi,
Yes if your design does not use current limiting (KI=1) then RIL=0. This means that you short the X pin of the devices to the source pin. This is not shown in the image on the GUI.
I hope this helps!
-Wesley