UVLO in tinyswitch4....needs BP/M pin to be cycled?

2 posts / 0 new

Hi,
With Undervoltage lockout in tinyswitch4, if current into EN pin gets less than 23.75uA then the part switches off.
Does the part immediately turn back on again when the current into the EN pin goes above 23.75uA, or does it need the BP/M voltage to be cycled?

HI treez,
Tinyswitch4 can turn back again with hysteresis of 3uA-8uA as long as BP/M pin current is >Isd(4mA-9mA).
Regards,
Jedidiah